2006 NISSAN 200sx Exterior Lighting Recall | May 24, 2006
Certain Ck Motorsports Combination Headlights, Clear Corner, Bumper, And Side Marker Lights Sold As Replacement Lamps For Use On The Passenger Vehicles Listed Above. Some Combination Lamps That Are Not Equipped With Amber Side Reflectors Fail To Conform To Federal Motor Vehicle Safety Standard No. 108, Lamps, Reflective Devices, And Associated Equipment.
Without The Amber Reflectors, The Vehicle Will Be Poorly Illuminated, Possibly Resulting In A Vehicle Crash Without Warning.
Summary Of Corrective Actions Taken: Ck Motorsport Will Notify Owners And Replace The Noncompliant Lamps Free Of Charge. The Recall Began On July 1, 2006. Owners May Contact Ck Motorsport At 1-909-610-7211.
This Recall Only Pertains To Aftermarket Replacement Equipment And Has No Relation To Any Original Equipment Installed On Vehicles Manufactured By The Vehicle Manufacturers.for More Information On The Lamp Model Numbers, Click On Document Search And View Document Titled “lamp Model Numbers.”customers May Contact The National Highway Traffic Safety Administration’s Vehicle Safety Hotline At 1-888-327-4236 (tty: 1-800-424-9153); Or Go To Http://www.safercar.gov.
This recall was issued on May 24, 2006 for 2006 NISSAN 200sx, manufactured by CK MOTORSPORT, INC., in response to Exterior Lighting problems.
1980 NISSAN 200sx Vehicle Speed Control Recall | Aug 28, 1980
Moisture Present In The Exhaust Gas Recirculation System May, Under Conditions Of Sub-zero Temperatures And Low Egr Flow Rate, Condense And Freeze In The Throttle Chamber. An Icing Condition Could Occur If The Vehicle Owner Fails To Adequately Warm Up The Engine Before Driving. This Could Prevent The Throttle From Closing Completely And Would Result In Higher Than Norman Idle Rpm.
Summary Of Corrective Actions Taken: The Dealer Will Install A Throttle Chamber Heating Kit To Prevent Icing At No Charge To Owner.
Vehicle Description: Passenger Vehicles.system: Throttle Linkages And Control; Throttle Chamber.consequences Of Defect: Should A High Idle Condition Occur When The Roads Arewet, Or Covered With Snow And Ice, Hard Braking Could Cause Loss Of Vehiclecontrol And Accident.
This recall was issued on Aug 28, 1980 for 1980 NISSAN 200sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Vehicle Speed Control problems.
1995 NISSAN 200sx Seat Belts,front,buckle Assembly Recall | May 24, 1995
The Front Safety Belt Buckle Release Buttons Can Break. These Red Plastic Release Buttons Are Marked “press.” If A Button Breaks, Pieces Can Fall Into The Buckle Assembly Causing The Buckle To Operate Improperly.
The Safety Belts Would Not Provide Adequate Protection To An Occupant In A Vehicle Crash.
Summary Of Corrective Actions Taken: Owners Should Promptly Check The Condition And Operation Of Both Front Safety Belt Buckles And Carefully Inspect The Red Release Button For Any Breaks Or Cracks. They Should Ensure That Both Buckles Are Operating Properly By Inserting Each Latch Plate Into Its Buckle, Tugging On The Belt To Make Sure The Latch Is Securely Locked, And Then Pressing The Release Button. The Latch Plate Should Pop Out Of The Buckle When The Button Is Pressed. If Either Release Button Shows A Sign Of Breaking Or Cracking Or If Either Buckle Fails To Operate Properly, Owners Should Promptly Contact Their Authorized Dealer To Schedule An Appointment To Have The Buckle Replaced Or Repaired Free Of Charge.
System: Interior; Seat Belts; Belt Buckles.vehicle Description: Passenger, Multi-purpose Vehicles And Light Duty Trucks Equipped With Safety Belts Made By Takata Corporation.note: If Your Vehicle Is Presented To An Authorized Dealer On An Agreed Uponservice Date And The Remedy Is Not Provided Free Of Charge Within A Reasonable Time, Please Contact Nissan At 1-800-647-7261.also Contact The Nationalhighway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.
This recall was issued on May 24, 1995 for 1995 NISSAN 200sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Seat Belts,front,buckle Assembly problems.
1995 NISSAN 200sx Service Brakes, Hydraulic,antilock Recall | Mar 01, 1995
The Anti-lock Braking System (abs) Hydraulic Actuator Was Not Properly Purged Of All Air During The Fill And Evacuation Process Causing Air Bubbles To Get Into The Brake System.
This Condition Can Cause Increased Brake Pedal Travel And Stopping Distances.
Summary Of Corrective Actions Taken: Dealers Will Bleed The Abs Hydraulic Actuator To Remove Any Air Bubbles In The Brake System.
System: Brakes; Hydraulic; Anti-skid.vehicle Description: Passenger Vehicles Equipped With Anti-lock Braking System.note: If Your Vehicle Is Presented To An Authorized Dealer On An Agreed Upon Service Date And The Remedy Is Not Provided Free Of Charge Within A Reasonable Time, Contact Nissan At 1-800-647-7261. Also Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.
This recall was issued on Mar 01, 1995 for 1995 NISSAN 200sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Service Brakes, Hydraulic,antilock problems.
1995 NISSAN 200sx Fuel System, Gasoline,fuel Injection System Recall | Nov 01, 1995
This Is Not A Safety Recall Campaign In Accordance With Federal Regulation 573. However, It Is Deemed A Safety Improvement Campaign By The Agency. The Campaign Will Replace The Fuel Injectors And Related Hoses Of Affected Vehicles Which Could Leak.
Fuel Leaks In The Engine Could Result In A Fire.
Summary Of Corrective Actions Taken: Nissan Dealers Will Replace The Fuel Injectors And Related Hoses On The Affected Vehicles.
Note: Nissan Has Decided To Conduct A Safety Improvement Campaign To Replace The Fuel Injectors And Related Hoses Without Charge. Owners Can Contact Nissan At 1-800-647-7261.
This recall was issued on Nov 01, 1995 for 1995 NISSAN 200sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Fuel System, Gasoline,fuel Injection System problems.
1998 NISSAN 200sx Visibility,windshield Wiper/washer,linkages Recall | May 05, 1998
Vehicle Description: Passenger Vehicles. Water Can Enter And Displace The Grease In The Wiper Arm Linkage Ball Joint Where The Wiper Linkage Attaches To The Wiper Motor Linkage.
This Can Result In Gradual Wear Over A Period Of Time Inside The Joint That Could Lead To The Separation Of The Wiper Linkage Assembly From The Wiper Motor Linkage At The Ball Joint. A Loss Of Windshield Wiper Function Can Result In This Separation Occurs.
Summary Of Corrective Actions Taken: To Prevent Grease From Being Washed Out Of The Joint, The Dealers Will Modify By Adding A Water Diversion Seal That Will Prevent Water From Entering The Windshield Wiper Linkage Ball Joint Area.
Owner Notification Is Expected To Begin August 14, 1998. Due To The Large Number Of Vehicles Involved, The Owner Mailing Will Be Phased And Will Continue Through December 31, 1998. Owners Who Take Their Vehicles To An Authorized Dealer On An Agreed Upon Service Date And Do Not Receive The Free Remedy Within A Reasonable Time Should Contact Nissan At 1-800-647-7261.also Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-888-dash-2-dot (1-888-327-4236).
This recall was issued on May 05, 1998 for 1998 NISSAN 200sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Visibility,windshield Wiper/washer,linkages problems.