NISSAN 240sx Seat Belts,front,buckle Assembly Recall | May 24, 1995

1995 NISSAN 240sx Seat Belts,front,buckle Assembly Recall | May 24, 1995

The Front Safety Belt Buckle Release Buttons Can Break. These Red Plastic Release Buttons Are Marked “press.” If A Button Breaks, Pieces Can Fall Into The Buckle Assembly Causing The Buckle To Operate Improperly.

The Safety Belts Would Not Provide Adequate Protection To An Occupant In A Vehicle Crash.

Summary Of Corrective Actions Taken: Owners Should Promptly Check The Condition And Operation Of Both Front Safety Belt Buckles And Carefully Inspect The Red Release Button For Any Breaks Or Cracks. They Should Ensure That Both Buckles Are Operating Properly By Inserting Each Latch Plate Into Its Buckle, Tugging On The Belt To Make Sure The Latch Is Securely Locked, And Then Pressing The Release Button. The Latch Plate Should Pop Out Of The Buckle When The Button Is Pressed. If Either Release Button Shows A Sign Of Breaking Or Cracking Or If Either Buckle Fails To Operate Properly, Owners Should Promptly Contact Their Authorized Dealer To Schedule An Appointment To Have The Buckle Replaced Or Repaired Free Of Charge.

System: Interior; Seat Belts; Belt Buckles.vehicle Description: Passenger, Multi-purpose Vehicles And Light Duty Trucks Equipped With Safety Belts Made By Takata Corporation.note: If Your Vehicle Is Presented To An Authorized Dealer On An Agreed Uponservice Date And The Remedy Is Not Provided Free Of Charge Within A Reasonable Time, Please Contact Nissan At 1-800-647-7261.also Contact The Nationalhighway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on May 24, 1995 for 1995 NISSAN 240sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Seat Belts,front,buckle Assembly problems.

NISSAN 240sx Service Brakes, Hydraulic,switches,brake Warning Recall | July 25, 1994

1994 NISSAN 240sx Service Brakes, Hydraulic,switches,brake Warning Recall | July 25, 1994

The Instrument Panel Brake Warning Light Will Not Illuminate When The Brake Fluid Level In The Master Cylinder Drops Sufficiently To Activate The Low Level Switch Due To An Improperly Wired Diode, Required By Fmvss No. 105, “hydraulic Brake Systems.”

Consequence Of Non-compliance: There Would Be No Indication To The Driver Of The Vehicle That Brake Fluid Was Low. Low Brake Fluid Can Be Caused By A Leak In The System Which May Result In Partial Or Complete Loss Of Brakes And An Accident.

Summary Of Corrective Actions Taken: Dealers Will Correct The Electrical Circuit For The Brake Warning System So That The Warning Lamp Will Illuminate When The Low Level Switch Is Activated.

System: Brakes; Hydraulic; Lamp Light; Brake Warning; Fmvss 105.vehicle Description: Passenger Cars.note: If Your Vehicle Is Presented To An Authorized Dealer On An Agreed Upon Service Date And The Remedy Is Not Provided Within A Reasonable Time And Free Of Charge, Or The Remedy Does Not Correct The Defect Or Noncompliance, Please Contact Nissan Service Center At 1-800-647-7261. Also, Contact The National Highway Traffic Safety Administration’s Auto Safety Hotline At 1-800-424-9393.

This recall was issued on July 25, 1994 for 1994 NISSAN 240sx, manufactured by NISSAN NORTH AMERICA, INC., in response to Service Brakes, Hydraulic,switches,brake Warning problems.